
Ultrasonic Cutter Maintenance Kit Refill for all ZO series cutters SB02
- In stock, ready to ship
- Inventory on the way
One of the worst things for a builder to deal with is an ultrasonic cutter that keeps going into safe mode. With the highspeed vibrations the blade anchor wears and wont seat properly making the cutter overheat faster and cut out. The vibrations of the cutter not only wear out the blade anchor but they also build up dirt on the inside of the tool. Using the Maintenance kit(SB01) you can easily clean out the cutter so that new holder wont wear out faster. This refill kit includes 10 pieces of abrasive paper for use with the SB01 kit.
- Insert clear abrasive sheet into the slot on the aluminum rod.
- Wrap the sheet around the rod, with the rough side facing out.
- Insert this assembly into the opening of the sonic cutter, and clean with a rotating motion.
Ultrasonic cutters are sharp and may cause injury if not used properly. Users are responsible to read the user manual fully and ensure that they are operating cutters safely. Next Level Neo is not responsible for any injuries incurred while using any ultrasonic cutters.